Specifications - Campbell Hausfeld CHN101 Manual Del Usuario

Operating Instructions
General Safety Information
(Continued)
This manual contains safety, operational
and maintenance information. Contact
your Campbell Hausfeld representative
if you have any questions.
OPERATOR'S RESPONSIBILITY:
The tool operator is responsible for:
• Reading and understanding tool
labels and manual.
• Selecting an appropriate tool
actuation system, taking into
consideration the work application
for which the tool is used.
• The safe use of the tool.
• Ensuring that the tool
is used only when
the operator and all
other personnel in the
work area are wearing ANSI Z87
eye protection equipment, and
when required, other appropriate
protection equipment such as
head, hearing and foot protection
equipment. Serious eye or
permanent hearing loss could result.
• Assuring that the tool is kept in safe
working order as described in this
manual.

Specifications

• REQUIRES: 0.8 SCFM with 10
fasteners per minute @ 90 psi
• AIR INLET: 1/4 inch NPT
• BRAD NAIL SIZE RANGE:
3/8 inch to 1-1/4 inch
• MAGAZINE CAPACITY:
100 Nails per load, 18 gauge
• WEIGHT: 2 lbs., 15 oz.
• LENGTH: 10-3/4 inch
• HEIGHT: 9 inch
• MAXIMUM PRESSURE: 100 psi
• PRESSURE RANGE: 60 psi – 100 psi
www.chpower.com
EMPLOYER'S RESPONSIBILITY:
• Selecting an appropriate tool
actuation system, taking into
consideration the work application
for which the tool is used.
• Ensuring that this manual is
available to operators and personnel
performing maintenance.
• The safe use of the tool.
• Enforcing that the
tool is used only when
the operator and all
other personnel in the
work area are wearing ANSI Z87
eye protection equipment, and
when required, other appropriate
protection equipment such as
head, hearing and foot protection
equipment. Serious eye or
permanent hearing loss could result.
• Assuring that the tool is kept in safe
working order as described in this
manual.
• Assuring the proper maintenance of
all tools in employer's possession.
• Ensuring that tools which require
repair are not further used before
repair. Tags and physical segregation
are recommended means of control.
Nozzle
Shield
Work
Contact
Element
(WCE)
2
GENERAL
•
Read and understand tool
labels and manual. Failure
to follow warnings,
dangers, and cautions
could result in DEATH or
SERIOUS INJURY.
•
Do not use any type of
reactive gases, including,
but not limited to, oxygen
and combustible gases,
as a power source. Use
fi ltered, lubricated, regulated
compressed air only. Use of a
reactive gas instead of compressed
air may cause the nailer to explode
which will cause death or serious
personal injury.
•
Use only a pressure-
regulated compressed
air source to limit the
air pressure supplied to
the tool. The regulated
pressure must not exceed 100 psi.
If the regulator fails, the pressure
delivered to the tool must not
exceed 200 psi. The nailer could
explode which will cause death or
serious personal injury.
•
Never use gasoline or
other fl ammable liquids
to clean the nailer. Never
use the nailer in the
presence of fl ammable
liquids or gases. Vapors could ignite
by a spark and cause an explosion
which will result in death or serious
personal injury.
Cap Exhaust
Trigger
Magazine
Nail Loading Area
Nail Discharge Area
O
CO
2
100 psi
Latch