Troubleshooting - ARAG 453 SERIE Uso Y Mantenimiento

10

TROUBlEShOOTING

FAUlT
The valve leaks or the seal of the
ball is not enough
The valve does not work
The valve does not stop at the
preset point
CAUSE
Presence of foreign bodies
Worn seals
Lack of power
Geared motor broken
Malfunction of the microswitches
in the geared motor
15
REmEDY
• Make sure there are no foreign bodies;
if so, remove them.
• Replace the seals.
• Check the connections, the cables, and
the controls. Replace the cable.
If the problem persists, contact your
nearest service centre.
• Replace the geared motor. The
instructions can be found on our Website
www.aragnet.com - ADDIN D30025.
• Contact your nearest assistance centre.
GB