Configurations - WEG CFW100-CBLT Guia De Instalacion

Bluetooth Communication Module
The procedures below must be observed for the proper
installation and start-up:
1. With the inverter de-energized, remove the front
cover of the inverter figure A.1 (a).
2. Fit the accessory to be installed as shown in figure
A.1 (b).
3. Power up the inverter.

5 CONFIGURATIONS

The CFW100-CBLT Communication Module has two
LEDs that indicate the communication status:
Red LED (ACTIVE): indicates that the is active.
„
Green LED (STATUS): indicates the CFW100-CBLT
„
module is with the serial communication service
active.
The CFW100-CBLT communication module presents
the following characteristics:
It enables the Bluetooth communication of the
„
product with other devices up to 10 meters away.
It can communicate with the SuperDrive G2
„
monitoring software application, version 9.6 or up
(see Figure A.2).
It allows the connection of only one device.
„
When connected to the inverter, the CFW100-CBLT
module enables the access to parameters P770
(Bluetooth Name). For further details, refer to the CFW100
Programming Manual.
ATTENTION!
For the proper operation of the CFW100
inverter with the CFW100-CBLT module,
parameters P310, P311 and P312 must be
set with the factory default values. For further
details refer to the CFW100 programming
manual version V2.0X or above.
NOTE!
The values of parameter P770 (Bluetooth
Name) and P771 (Bluetooth Password) are
used in the configuration of the Bluetooth
Adapter.
6 | CFW100