Assembling The Pedals - Look ZED 3 Manual Del Usuario

EN

ASSEMBLING THE PEDALS

Trilobe washer
Trilobe nut
Pedal
ZED crankset
Fig 11
Adjusting the length of the cranks:
Position the arrow on the support washer facing the desired length marker then position the trilobe nut
on the other side in the same position. Screw the pedal to the recommended torque. The ZED 3 crankset
is compatible with every pedal on the market.
Attention:
• Carefully check the position of the trilobe nut in each of the two cranks before cycling in order to be
sure that you have positioned the right or left cranks at the same lengths. If the right and left cranks are
different lengths this can cause serious physical injury.
• The recommended torques must be respected when tightening the pedals (20 Nm minimum for LOOK
pedals). Failure to respect the torques can cause damage to the product and, as a result, lead to
accidents, physical injuries or death.
• Degrease and clean the surface of the nut that is in contact with the crank before fitting the pedals.
Dust and/or any other particles on the trilobe nut or on the crank could damage the crankset or pedal.
• The right nut (to be fitted on the right crank) is identified by the letter R, and the left nut (to be fitted on
the left crank) features the letter L.
37