Descargar Imprimir esta página

Cosatto HOLD Manual Del Usuario página 7

Ocultar thumbs Ver también para HOLD:

Publicidad

Idiomas disponibles

Idiomas disponibles

10 - removing the harness and child car seat liner
Loosen off the shoulder straps push inwards the release catch under the flap (a) and pull
forward the shoulder straps (b). Remove the shoulder straps off the harness
connector (c) at the rear of the seat. Pull the ends of the shoulder straps through the
slots in the seat.
Release the crotch strap clip underneath the child car seat (d) and push the clip through
the slot in the child car seat and child car seat liner (e).
Remove one of the chest pads and pull the shoulder strap out of the buckle (f). Lift the
seat cover where the waist straps fit through the child car seat. Pull the shoulder strap/
waist strap through the seat cover and the underside of the seat (g). Keep pulling the
shoulder strap/waist strap from the seat and seat cover until it is clear of the seat (h).
Release the catch (a) then pull the harness adjuster strap out of the rear of the seat (i).
Refitting is a reversal of this procedure.
11 - fitting the raincover
Place the raincover over the child car seat as shown.
®
There is a flap, fastened by a Velcro
tab, at the top of the raincover (a) to allow access
to the carry handle.
Never leave raincover on indoors, in a hot atmosphere or near a heat source as your child
could overheat.
12 - removing the child car seat cover
Remove the harness and child car seat liner (See step 10).
Pull the elastic bead on the child seat cover away from the child car seat (a).
Unhook the child seat cover (b) From under the vehicle seat belt guides (c).
Work around the edge of the child car seat until the cover can be pulled clear.

Publicidad

loading