Set The Boundary Width And Test The Receiver Collar - Guardian Fence Guía De Uso

Function and Response Table
Indicator Light
Response
1 Flash
2 Flashes
3 Flashes
Flashes once
every 5 seconds
Set the Boundary Width and
Step
6
Test the Receiver Collar
Use the Boundary Width Control knob to set the width of the
Warning Zone and Static Correction Zone (6A). Set the Boundary
Width as wide as possible to give your pet the widest Warning and
Static Correction Zones without reducing the Pet Area too much. We
recommend an 12'-20' Boundary Width.
Note: The Boundary Width Control knob does not change the Static
Correction Level.
To identify the Warning and Static Correction Zones, make sure the
Receiver Collar battery is properly installed, the Static Correction Level
is set at 2 or 3, and the Test Light contacts are held to the Contact
Points (6B). For best results, select a section of straight Boundary Wire
that is at least 50 feet long. Hold the Test Light contacts to the Contact
Points (6B).Walk toward the Boundary Wire with Contact Points
pointing up and holding the Receiver Collar at your pet's neck level
(6C) until the Receiver Collar beeps (6D) and the Test Light fl ashes.
Note: The Receiver Collar is waterproof, which can make the beep hard to hear.
If the Receiver Collar does not beep at the desired range, adjust the
Boundary Width Control knob to the desired setting. Turning the
Boundary Width Control knob clockwise increases the Boundary
Width while turning it counterclockwise decreases it (6A).
Repeat this activity as needed until the
Receiver Collar beeps at the desired
distance from the Boundary Wire. The
numbers on the Boundary Width Control
knob indicate signal strength and are not
representative of Boundary Width footage.
If using a Double Loop, you may need to
increase the separation of the Boundary
Wire to achieve desired range.
The Receiver Collar beeps as a warning
tone and ticks when delivering a Static
10
Static Correction
Level
1
2
3
Low Battery
Customer Care Center 1-800-732-2677
Receiver Collar Temperament
Function of Pet
No Static Initial Training
Correction, Mode
Tone Only
Low Static Timid
Correction
High Static High energy
Correction
6C
6A
5
2 8
5
2 8
6B
6D
Boundary
Wire