Kalorik USK STP 20159 Manual De Instrucciones página 6

Fax +32 2 359 95 50
When changing the setting from a higher selection to a lower
•
setting allow several minutes for the pressing plate to cool
sufficiently after making the change.
Kind of textile
Nylon
Silk
Rayon
Wool
Cotton
Linen
NOTE: You may find it more efficient to arrange your fabrics from
those requiring the lowest setting to those requiring the highest
setting and proceed accordingly. This will avoid any unnecessary
delay or wait for the pressing plate to cool.
STEAM CONTROL
Steam is produced only when the yellow steam ready light is on.
•
The green ready light goes off when the unit has reached the
•
desired temperature. The yellow steam ready light will come on
when the unit is ready to produce steam.
If this is the first time you are using the steam press or you have
•
been storing it for some time, lift the pressing plate into the raised
position and press the burst of steam button several times until the
steam begins to flow.
The burst of steam function can only be used when the steam
•
ready light is on AND the steam press is in a slightly opened
position. Do not use the burn of steam function when the steam
press is closed, or you may damage the unit.
Do not press the burst of steam button for more than 5 seconds or
•
water may drip on your garment.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Temperature
100°C / 212°F
130°C / 266°F
140°C / 284°F
160°C / 320°F
200°C / 392°F
210°C / 410°F
6
Assembly page 6/24
special instruction from Team
Print only
Steam
NO
NO
NO
YES
YES
YES
USK STP 20159 - 110127