Wayne Dalton 8000 Instrucciones De Instalación Y Manual Del Usuario página 11

IMPORTANT: READ INSTRUCTIONS TITLED "P4" "REMOVING THE OLD DOOR" ON PAGE 9 AND "P5" "PREPARING THE OPENING" ON
PAGE 10 BEFORE ATTEMPTING DOOR INSTALLATION.
IMPORTANT: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS MUST BE USED WHEN INSTALLING CENTER BEARING BRACKETS,
END BRACKETS, JAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS ON TREATED LUMBER
(PRESERVATIVE-TREATED). STAINLESS STEEL LAG SCREWS ARE NOT NECESSARY WHEN INSTALLING PRODUCTS ON UNTREATED
LUMBER.
NOTE: It is recommended that holes 5/16" x 1-5/8" lag screws be pilot drilled using a 3/16" drill bit. Holes for 1/4" x 2" lag screws and
1/4" x 1-1/2" lag screws be pilot drilled using a 1/8" drill bit, prior to fastening.
1
Horizontal Angle
Tools Needed:
Position the horizontal angle as shown.
Place tabs of horizontal angle in the key
Hammer
slot of horizontal track. Using a hammer,
tap the horizontal angle towards the
curved end of the track until the hole in
track and angle are aligned. Set tracks
aside.
NOTE: For larger doors, a full length
horizontal angle may be spot welded
to the horizontal track. If the horizontal
angle is not welded, the horizontal angle
will be installed as shown.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
TABS
HOLE
HORIZONTAL TRACK
HORIZONTAL ANGLE
HORIZONTAL
ANGLE
KEY SLOT
HOLE
HORIZONTAL
TRACK
HORIZONTAL
HORIZONTAL
TRACK
ANGLE
HORIZONTAL
TRACK
TABS
11