Wayne Dalton 8000 Instrucciones De Instalación Y Manual Del Usuario página 25

17
Attaching Quick Install Flagangle
HORIZONTAL
to Horizontal Track FLAGANGLE
TRACK
Tools Needed:
NOTE: If quick install fl agangle was
installed in Step 16, skip this step and
9/16" Socket
continue with Step 18. If not, complete
this step.
KEY SLOT
Ratchet Wrench
Align key slot of the horizontal track
9/16" Wrench
QUICK
with the quick install tab of the
INSTALL
fl agangle. Push curved portion of
Level
TAB
horizontal track down to lock in place.
Hammer
WARNING
VERTICAL
DO NOT RAISE DOOR UNTIL
TRACK
HORIZONTAL TRACKS ARE
SE CURED AT REAR, AS OUTLINED
IN STEP 20, OR DOOR COULD
FALL FROM OVERHEAD
POSI TION CAUSING SEVERE OR
FATAL INJURY.
HORIZONTAL
FLAGANGLE
TRACK
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the fl agangle using (1) 3/8"- 16 x 3/4"
QUICK
truss head bolt and (1) 3/8"- 16 hex
INSTALL
TAB
nut. Repeat for other side. Remove the
nail that was temporarily holding the top
section in place, installed in Step 15.
KEY SLOT
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE
VERTICAL
TO TOP SECTION. TRACK
3/8- 16 X 3/4"
TRUSS HEAD BOLT
HORIZONTAL ANGLE
3/8"- 16
HEX NUT
FLAGANGLE
25
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com