Assembly - Weston 82-0250-W Manual Del Usuario

ASSEMBLY

!
WARNING
cleaning, disassembling or assembling.
1. Insert the Auger into the Head.
2. The place the screen over the auger and
line up notch with the tab located on the
bottom of the Head. Hold screen in place.
3. Slide the Front Ring Nut over the Screen
(make sure the tabs on the Screen remain
aligned with the notches on the Head). DO
NOT over-tighten the Front Ring Nut to
avoid damaging the Motor during operation
(FIGURE C).
4. Insert assembled Screen and Head into
the large opening of the Chute. Make sure
that the end of the Screen exits the smaller
opposite opening. The assembled Screen
and Head will click into place (FIGURE D).
5. Align the notches on the Grinder Head
with the tabs on the Main Body.
6. Press the Grinder Head against the
Motor and rotate it counterclockwise until it
locks into place (FIGURE E).
7. Rotate the Chute until the desire angle is
reached.
ENTANGLEMENT HAZARD: Disconnect power before
FIGURE C
FIGURE D
FIGURE E
9