Wall Control Operation; Testing Your Fan - Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones

11. Wall Control Operation.

slider control - controls fan
L1 position - LOW speed
L2 position - MEDIUM-LOW speed
M position - MEDIUM speed
H position - HIGH speed
O position - OFF
slider control - controls light brightness and
ON/OFF

12. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box. Test fan speeds with wall control. Start at the
OFF ("O") position (no blade movement) and try
each of the 4 different fan speeds using the slider
control on the right side of the wall control (
Test the light ON/OFF and dimmer function with
the slider control on the left side of the wall
control ( ). If fan and/or light do (does) not
function, please refer to "Troubleshooting" section
to solve any issues before contacting Customer
Service.
Turn fan completely off before moving the reverse
switch (located on top of motor housing). Set
reverse switch to recirculate air depending on the
season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT
for fan to function. If the reverse switch is set in the
middle position (diagram 3), fan will not operate.
motor
housing
(topside)
).
reverse switch
diagram 1
page 9
L
1
L
2
M
H
O
diagram 2 diagram 3