Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones página 9

10. Light Kit Assembly. (cont.)
Remove 1 screw from underside of fitter plate
motor housing
and partially loosen the other 2 screws.
Connect WHITE wire from motor housing to
WHITE wire from light kit fitter. Connect BLACK
(or BLUE) wire from motor housing to BLACK
wire from light kit fitter. Be sure molex
connections snap together securely.
fitter plate
Carefully arrange wiring in fitter plate and align
nodule
slotted holes in light kit fitter with loosened
screws in fitter plate. Twist light kit fitter to lock.
molex
Re-insert screw that was previously removed
connections
and tighten all 3 screws securely.
light kit fitter
Install two 50 watt max. halogen bulbs, type JD
bulb
E11 (included).
Important: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
touching them.
Tip: Do not touch glass portion of bulb with
glass shade
slot
fingers or hands. Oil from skin can cause bulb to
overheat and go out prematurely. Use cardboard
box or foam wrapping bulb was packed with to
layer around glass portion of bulb.
Align grooves on glass shade with nodules on
inside of fitter plate and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
page 8