Troubleshooting; Fcc Notice - Commercial Electric CER6CP6743 Instrucciones De Instalación

ASSEMBLY AND INSTALLATION
1. Plug the MALE CONNECTOR to the FEMALE CONNECTOR of top of the RETROFIT
TRIM. (FIG. 9)
2. Squeeze both TORSION SPRING arms together and insert into the C-CLIPS of the CAN.
(FIG. 10)
3. Tuck all wires into the CAN and carefully push the RETROFIT TRIM into CAN. (FIG. 10)
For a complete list of compatible dimmers, please look up the item number listed on the cover
of this instruction manual at www.homedepot.com or www.homedepot.ca.
SYMPTOM POSSIBLE CAUSE
Wall switch or circuit breaker is off.
Incorrect or loose wire connections.
The light does
not turn on.
LED connection is loose
LED driver has malfunctioned.
FIVE-YEAR LIMITED WARRANTY

Commercial Electric warrants this product to be free from defects in material and
workmanship for five years from the original date of purchase by the consumer. This warranty
is limited to the counter replacement at the time of purchase, with the original purchase receipt.

Commercial Electric will not be liable for the loss or damage of any kind, incidental or
consequential damages of any kind, whether based on warranty contract or negligence, and
arising in connection with the sale, use or repair of the product claimed to be defective. Some
states do not allow the exclusion or limitation of incidental or consequential damages so the
above limitation may not apply to you. This warranty gives you specific legal rights and you
may also have other rights, which vary from state to state. Misuse, accident, improper
installation or maintenance will also void the warranty.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiver antenna.
 Increase the separation between the equipment and receiver.
 Install the product onto on a circuit different from that to which the receiver is connected.
 Consult with the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes made to the electronics circuit will void this equipment's compliance
with Part 15 of the FCC Rules and should not be operated.
___________________________________________________________________________
Conforms to standard ICES-CAN 005 (B) / NMB-005 (B)
DIMMING

TROUBLESHOOTING

Turn on switch or circuit breaker.
Check wire connections.
Push the LED connectors from the
housing and trim tightly.
Replace LED retrofit trim.

FCC NOTICE

ALL RIGHTS RESERVED. COPYRIGHT  COMMERCIAL ELECTRIC 2017
SOLUTION
LIGHT DISTRIBUTION MAP
0
80
160
240
320
400
Fig. 9
Fig. 10
Bottom
View