Cleaning And Maintenance; Routine Maintenance; Special Maintenance; Control And Safety Devices - Gastrodomus GFP745 Manual De Instrucciones, Uso Y El Mantenimento

3.

CLEANING AND MAINTENANCE

3.1 ROUTINE MAINTENANCE

At the end of the working day, clean the appliance, both for reasons of hygiene and to prevent operating faults.
Do not clean the appliance with direct or high-pressure jets of water, is forbidden to use flammable materials, solvents,
and do not use metal pads, brushes or scrapers in normal steel. If necessary, use stainless steel pads, but do not rub
them against the grain of the metal of the appliance.
Use warm soapy water on steel surfaces and then rinse in plenty of water and dry with a soft cloth. Maintain the shine by
regular polishing with a normal liquid polish.
Do not wash the work top or floor with hydrochloric acid.
OIL-COLLECTING TANK
Check regularly that the oil level does not reach the brim of the oil collector and that the filter is free. Empty it regularly
and clean the filter. The pull-out handle on the top edge makes it easier to catch hold of the tank.

3.2 SPECIAL MAINTENANCE

At regular intervals (at least once a year or more often in cases of frequent use), service the appliance thoroughly.
This includes checking the gas circuit, checking parts for damage and if necessary lubricating the taps if they are difficult
to use. Contact an authorized technician and possess the necessary professional requirements. A maintenance contract
should be taken out with a centre approved by the company.

3.3 CONTROL AND SAFETY DEVICES

If the appliance is not used for a long time or if it does not work or works irregularly, the gas stopcock upstream of the
appliance must be shut off.
All the parts of the appliance that are subject to wear can easily be accessed from the front of the appliance by opening
the door or after removing the front.
All the couplings use a dado and bicono, so great care must be taken in handling these components. If the part is
damaged during dismantling or reassembly it must be replaced with a new one.
If the oil exceeds the set temperature the safety thermostat breaks the contact with the thermocouple. To restart the
appliance, open the door and press the red push-button.
Warning. As the safety thermostat may have been triggered by a faulty gas valve or thermostat, any faulty parts must be
replaced by an authorized technician before the appliance is started up again.
THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR HARM CAUSED BY
INCORRECTINTERVENTIONS, TAMPERING WITH THE APPLIANCE, MISUSE, POOR MAINTENANCE,
NONCOMPLIANCEWITH CURRENT REGULATIONS AND INEXPERT USE.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY THE FEATURES OF
THEAPPLIANCES DESCRIBED IN THIS MANUAL.
Pag. 19