Backup Memory Card; Changing The Type Of Channel Output; Adjusting The Timing; Remote Learning - Vimar Elvox ECRU Manual Para El Conexionado Y El Uso

11. BACKUP MEMORY CARD

In the normal operating mode, pressing button P1 for 6 seconds will save all the settings of the receiver and all the codes of
the learned remote controls to the Backup Memory Card, which must be properly inserted in the connector CN3. The Card can
then be removed. In the normal operating mode, pressing button P2 for 6 seconds will load the receiver with all the settings and
all the codes of the remote controls contained on the Backup Memory Card, which must be properly inserted in the connector
CN3. The Card can then be removed.

12 . ChANGING ThE TYPE OF ChANNEL OUTPUT

In the normal operating mode, on pressing button P1 the DL1 LED will start flashing at high frequency, with the colour for the
type of output associated with channel Ch1
Colour
Green
Red
Orange
With the receiver in the mode for changing the type of output:
- Pressing button P2:
changes the type of output associated with the channel displayed. The colour of the LED changes accordingly.
- Pressing button P1:
switches to displaying the type of output of the next channel
- After 15 seconds of inactivity:
the receiver automatically quits the channel 4 learning mode and returns to its normal operating state (see point 4).
13 . SETTING ThE TIMING
If the output of a channel is configured for the timed type (see point 12), this output remains activated for a time ranging from 5
to 240 sec, adjustable via trimmer TR1.

14 . REMOTE LEARNING

If Jumper JP1 is positioned between 2 and 3 the remote learning function is enabled. Simultaneously pressing the first three
buttons of a 4-button rolling code remote control already stored in the receiver the four LEDs DL1...DL4 will flash and an
intermittent beep will be emitted (remote learning mode).
With the receiver in remote learning mode.
- Activating a remote control saved for activating the Ch1 output:
the receiver goes into Ch1 channel learning mode (see 5).
- Activating a remote control saved for activating the Ch2 output:
the receiver goes into Ch2 channel learning mode (see 6).
- Activating a remote control saved for activating the Ch3 output:
the receiver goes into Ch3 channel learning mode (see 7).
- Activating a remote control saved for activating the Ch4 output:
the receiver goes into Ch4 channel learning mode (see 8).
- After 15 seconds of inactivity:
the receiver returns to its normal operating state (see 4).
EN
.
Operation
Monostable
Bistable
Timed
11