Chef's Choice 720 Manual De Instrucciones página 5

ASSEMBLING THE GRINDER FOR THE FIRST TIME
1. Always make sure the grinder is not plugged in during assembly.
2. Place the motor housing on a clean, dry, smooth, horizontal surface.
3. Insert the assembled grinder assembly (which includes items 1 to 5) into the opening of
the motor housing. Make sure the locking knob (12) screw is fully retracted and does not
interfere with the insertion. Slightly twist the grinder head back and forth to ensure it
seats properly into the motor housing. Tighten the locking knob snugly until the grinder
head is properly secured in the motor housing. Do not overtighten the locking knob.
4. Place the hopper (7) on top of the feed/grinder tube (5).
5. Insert the food pusher (6) into the hopper opening.
DISASSEMBLING AND RE-ASSEMBLING
1. Make sure unit is turned off and unplugged.
2. Remove the food pusher (6) and lift off the hopper (7).
3. Remove the grinder head assembly from the motor housing by first loosening the
locking knob (12) and then, with a slight back and forth twisting motion, pull out the
grinder head assembly.
4. While firmly holding the grinder head assembly, loosen and remove the locking ring.
(Tip: it may be easier to loosen the locking ring while grinder is fully assembled.)
5. Carefully remove the grinding plate (2). (Caution! The holes have sharp edges.)
Observe that the grinding plate has a half circle notch which aligns with a similarly
shaped key in the feed/grinding tube.
6. Next, carefully remove the cutting blade (3). (Caution! The blade has very sharp
edges.) Observe that the flat sides of the cutting blades face and are adjacent to the
grinding plate. It is extremely important that when re-assembling the grinder head,
the cutting blade be properly positioned. Failing to do so may damage the unit.
7. Now, pull out the auger (4).
8. To assemble the grinder head, follow the above steps in reverse.
NOTE: DO NOT OVER-TIGHTEN LOCKING RING
Before using the grinder for the first time, lift the food hopper from the feed tube and
then remove the grinder assembly from the motor housing and disassemble it (as
described above) for cleaning. Wash the locking ring, grinding plate, cutting blade, auger,
feed/grinding tube, food pusher and hopper in warm soapy water. Blow away water from
the holes in the grinding plate. (Tip: A hair dryer works very effectively, but do not use
the "high" heat setting.) Coat the grinding plate, cutting blade locking ring and auger
sparingly with vegetable oil or other USDA approved food grade lubricant.
After re-assembling the grinder assembly, insert it into the motor housing and place the
hopper on top of the feed tube. Insert the food pusher into the hopper opening. Make
sure all parts are in the correct position and properly secured.
The Power switch for the grinder has four positions. Placing the power switch in the number
1 position runs the grinder at a low speed intended for sausage stuffing. Position 2 on the
power switch runs the grinder at full speed intended for most grinding. "REV" puts the motor
temporarily in reverse for clearing jams. In the Off position, the grinder is powered off.
1. Make sure the power switch is in the "OFF" position.
2. Insert plug into a 120V, 60Hz, power outlet.
3. Place a sufficiently large bowl under the grinder assembly.
THE GRINDER HEAD
USING THE GRINDER
English — 5