Check Before Treatment - NSK Ti Max nanoSG20LS Operation Manual

5-3 External and Internal Irrigation together
This method is available only for a drill with the internal spray system.
1) Connect the ends of the Y-Connector to the External and Internal Spray Nozzles as detailed in 5-1 and
5-2.
2) Connect the Irrigation Tube to the Y-Connector firmly. (Fig. 5)

6. Check before treatment

Check that the Head Cap is firmly tightened. Also check for handpiece vibration, noise and overheating. If
any abnormalities are found do not use the handpiece and contact your Authorized NSK Dealer.
7. Maintenance
After each patient maintain the product as follows.
CAUTION
Immediately after use, the product should be cleaned, lubricated and sterilized. If blood remains on the external or internal surfaces it can
become clotted and cause rust.
8
Y-Connector
Irrigation Tube
Fig. 5