Top View - Swing-N-Slide Kodiak NE 5010 Instrucciones De Ensamblaje

Fig. 18
3-1/2''
31
Q. Swing Beam Drill Locations
1. Use a 3/8" drill bit to drill a 3/8" hole through the
center of the beam at each location shown in
(Fig. 18)
2. Install Swing Hangers onto swing beam at
locations shown.
Note: Swing Hangers must be installed on
same side dimensions were originally marked.

TOP VIEW

Drill 3/8''
Hole
PROJECT 515