Swing-N-Slide Kodiak NE 5010 Instrucciones De Ensamblaje página 34

PROJECT 515
Fig. 22
T-nut
Washer
2-1/2" screws
5-1/2" Hex Bolt
2-1/2" screw
T. A-Frame Assembly cont.
1. Tap T-nut into 3/8" hole as shown in (Fig. 22)
Note: If using Laminated Swing Beam, make sure T-nut teeth do not fall between seams of 2" x 6"s.
2. Attach A-Frame beam to Swing Beam using (2) 5-1/2" hex bolts and 4 screws.
3. Tighten hex bolt to flush with top of T-nut. Repeat on other bracket.
34