Error Messages - EMKO ESM Serie Manual Del Usuario

Alarm
Output
Deviation Range
High Alarm

Error Messages

°C
1- Sensor failure in analog inputs. Sensor connection is wrong or there is
°F
no sensor connection.
PO PS
AO AS
PSET ASET
P
°C 2- If value that is read from the analog input is lower than process set
°F
low limit parameter
PO PS
the picture.
AO AS
PSET ASET
P
°C 3- If value that is read from the analog input is higher than process set high
°F
limit parameter value
PO PS
the picture.
AO AS
PSET ASET
P
4- If programming section entering password is different from "0" and user
°C
°F
accesses to the parameter by ASET/OK button without entering the
PO PS
password and wants to change a parameter, the warning message is
AO AS
shown on the bottom display as shown on the left. Device does not allow
PSET ASET
to do any changes without entering the password correctly.
P
5- In programming section, when Tune operation is selected
°C
°F
warning which is shown on the left blinks in operation screen for 10
PO PS
seconds, it means that start conditions is not okay for Tune operation.
AO AS
PSET ASET
P
Installation
c
Before beginning installation of this product, please
read the instruction manual and warnings below carefully.
In package ,
-One piece unit
-Two pieces mounting clamp
-One piece instruction manual
( -
ON
OFF
, value on the top display starts to blink like on
, value on the top display starts to blink like on
)
Process Value
, if
13