Panel Mounting - EMKO ESM Serie Manual Del Usuario

ESM-9420
48mm / 1.89 inch
ESM-9920
°C
°F
96mm / 3.78 inch

Panel Mounting

3
2
5
4
°C
°F
PO PS
AO 1 AS 1
AO 2 AS 2
Temperature
Controller
PSET ASET
P
ESM-9420
10.5 ± 1 mm /0.41 inch
PO PS
AO 1 AS 1
AO 2 AS 2
PSET ASET
P
Temperature Controller
ESM-9920
12 ± 1 mm /0.47 inch
1
1-Before mounting the device in your panel, make sure
that the cutout is of the right size.
2-Check front panel gasket position
3-Insert the device through the cutout.If the mounting
clamps are on
the unit, put out them before inserting the unit to the panel.
4-Insert the unit in the panel cut-out from the front side.
5- Insert the mounting clamps to the holes that located
top and bottom sides of device and screw up the fixing
screws until the unit completely immobile within the
panel.
Maximum 15mm / 0.59 inch
PO
AO
84 mm / 3.31 inch
Maximum 15 mm / 0.59 inch
84 mm / 3.31 inch
6