Premier AB-3954AUGA Manual De Instrucciones página 10

Simple troubleshooting of Cool Humidifier
Reasons
Problems
Indicator light Doesn't insert plug
isn't light. No well
wind, No mist
Doesn't open
power switch
Indicator light No water in the
illuminate water tank
Having wind Doesn't open Auto
temperature knob
No mist
Doesn't press float
cover well
New product
The mist is Whether the water
smelly tank or water is
cleaned
Indicator light Too much water in
illuminate the water tank
No wind
No mist
Transducer is
The amount of clogged with dirty
Dirty water or
mist is very
small water is stayed
too long time in
water tank
P-8
All manuals and user guides at all-guides.com
Handling ways
Insert plug well
Open power switch
Fill with water in water
tank
Open Auto temperature
knob by clockwise
Press float cover well
Open the water tank for
12 hours in the cool
place
Clean the water tank
and change the water
Decrease some water
and tighten the cover.
Clean the transducer
Change the clean water
CLEANING AND MAINTENANCE
▲ Unplug the unit before cleaning
▲ Any greasy dirt on the fan and fan blade should be cleaned with
clean and mild detergent and soft cloth.
! Before using every time, put some Engine oil between motor shaft and bearing.
Notice: If power cable is damaged, it must be changed with special flexible wire
or bought the special component from factory or maintenance department.
Disassembly
Diagram 1
First, disassembly the fan to diagram
Clean the greasy dirt on the fan so as not to change the color or cause damages
1)Clean with detergent and soft cloth
2)Avoid flushing with water directly
3)Avoid cleaning with thinner ,toluene, acidity, kerosene, essentials oils, chemistry so as not to
change the color or cause damages.
After cleaning,keep it in the dry place
Maintenance of Cool Humidifier
unplug the unit before cleaning.
Cleaning of water tank (once a week)
If there is dirt in the water tank, clean it with
detergent and flush it with clean water
Cleaning of Humidifier outside:
Put the soft cloth rinsing under 40 degree water,
clear the dirt, the mist cover must be cleaned carefully.
Notices of cleaning:
1) It is not allow to touching transducer with sharp tools,
just cleaning with soft wet cloth.
2) Don't use the cloth with chemical solvents gasoline kerosene
polishing powder to wipe the fan appearance.
Diagram 2
P-9