KitchenAid KFC0516 Manual De Instrucciones página 7

USING THE FOOD CHOPPER
ASSEMBLING AND RUNNING THE FOOD CHOPPER
IMPORTANT: Be sure the Food Chopper is unplugged before assembling.
1
2
3
NOTE: Do not try to install more than one accessory at a time. The Food Chopper will
operate with either the blade or the whisking accessory in place, not both.
4
IMPORTANT: Do not process coffee beans or hard spices such as nutmeg as they may
damage the Food Chopper.
5
NOTE: The work bowl and lid must be locked into place for the Food Chopper to
operate.
W11201342A_Book.indb 7
Start with the work bowl handle facing front on the
base. Rotate the handle 90° counterclockwise to lock
into place. When assembled properly, the handle will
face the right side.
Fit drive adapter over the shaft in the center of the
work bowl, then rotate and lower the drive adapter
until it rests at the bottom of the work bowl.
If using the blade, fit the blade over the drive
adapter, then rotate and lower the blade until it rests
at the bottom of the work bowl. If using the whisk,
see "Using the whisking accessory" section.
Place ingredients to be processed inside the work
bowl. For uniform consistency of processed foods,
cut fruits, vegetables, and meats into 1-inch pieces.
Place the lid on the work bowl with the lid handle
facing front. Rotate the lid handle counterclockwise
until it locks into place. The lid will click when
properly locked into place.
USING THE FOOD CHOPPER | 7
7/10/2018 2:52:13 PM