illy Francis Francis X1 Manual De Instrucciones página 44

PROBLEM
You turn on the machine but the red LED
does not light up.
The machine does not make coffee.
You open the steam knob and the machine
does not make steam.
Steam comes out but it does not froth the
milk.
Water leaks out of the brew group during
brewing.
fast beeps and flashing red LED
The "OK" LED is flashing (White)
Water leaks from the inside of the machi-
ne.
The LED (RED) is steadily lit.
Note: If the problem persists, contact an authorized service center.
40
SOLUTION
Check the mains electrical connection; check the status of the circuit breakers protecting the home electrical sy-
stem.
Carry out the following operations:
- fill the water tank; make sure it is fitted completely into place.
- Check that the steam knob is closed.
- Remove the capsule holder from the coffee brew group.
- Wait until the "OK" LED is steadily lit (BLuE) (machine ready to brew).
- Place a container underneath the brew group and press down the coffee switch.
- Dispense water for a few seconds.
- Stop the flow.
- Insert a new capsule in the capsule holder and insert into the brew group; proceed with making coffee.
Case a) If the "OK" LED is flashing (GREEN) ; wait for it to become steadily lit.
If the "OK" LED (GREEN) is not lit; press down the steam switch and wait for the "OK" LED it to become
Case b)
steadily lit (GREEN).
Possible clogging of the steam wand: switch off the machine; wait for it to cool down (at least an hour); remove
Case c)
any obstructions from the outlet holes of the steam wand. (see chapter "cleaning and maintenance").
Insert a new capsule in the capsule holder and fit it to the brew group; proceed with making coffee.
Carry out the following operations:
- Switch off the machine.
- fill the tank.
- Place a container under the steam wand and open the steam knob.
- Switch on the machine and wait about 10 seconds.
- Close the steam knob and wait for the "OK" LED to light up (BLuE)
Carry out a descaling cycle.
Switch off the machine and unplug it. Contact an authorized service center.
The machine is in the "POWER SAVE" mode; to bring it back to normal operating conditions press down one of the
two switches (Coffee or Steam).