Intellinet 502917 Manual De Usuario página 2

PoE Web-Smart Switch • User Manual
Thank you for purchasing the Intellinet Network Solutions
Smart Switch, Model 502917.
CONNECTIONS & INDICATORS
Ports
Each of the eight ports
can be used to deliver
both power (up to
15.4 Watts per port)
and data to remote
devices. All ports on the switch support Auto-MDI/MDI-X functionality, so
crossover cables and uplink ports are not needed for connections to PCs,
routers, hubs, other switches, etc. If an LED doesn't indicate a link or activity,
check the corresponding device for proper setup and operation.
LEDs
The Power, PoE and Link/
Act LEDs make it easier to
monitor connections.
NOTE: Powered devices
should also comply with
IEEE 802.3af.
Power
On the rear panel, plug in the included power
cord and connect the switch to an AC outlet.
Toggle the Power switch to On and confirm that
the Power LED is lit.
INSTALLATION
Prior to use, position the switch:
• on a level surface with 25+ mm (approx. 1") of clearance for ventilation;
• away from sources of electrical noise: radios, transmitters, amplifiers, etc.;
• within 100 m (approx. 328') of connected network devices.
For rack mounting, align the two brackets with the holes on each side panel
and screw in place.
2
ENGLISH
2 4 6 8
PoE
LINK /ACT
PoE
POWER
LINK /ACT
1 3 5 7
LED Status
POWER On
Off
PoE On
Off
LINK/ACT On
Blinking
Off
8-Port PoE Web-
™
8 RJ45 10/100M ports
2 4
1 3
Operation
Power on
Check the AC connection; power on
Port is linked to a PoE device
No PoE device is linked
Valid port connection
Valid connection; data transmitted/received
No link established
ON
OFF
English
6 8
5 7