Introduction To Your Newr 301 Series "D" • R 301 Ultra Series "D; Switching On The Machine; Advice On Electrical Connections; Control Panel - Robot Coupe D Serie Manual De Instrucciones

INTRODUCTION TO YOUR
NEW R 301 Series "D"
• R 301 Ultra Series "D"
The R 301/R 301 Ultra is a versatile machine
designed to meet your professional needs. It can
perform a number of tasks, as well as save much in
time and labor.
This food processor consists of a bowl assembly
and vegetable preparation attachment. The 3.5
quart bowl is used for chopping, grinding, pureeing,
blending, mixing, and kneading of ingredients
required in most every recipe.
A wide range of cutting plates are available for use
with the vegetable preparation attachment. Cutting
plates are available for slicing, waved slicing,
grating, pulping, and julienne.
A citrus juicer accessory is also available.
Its numerous functions will open the door to a whole
new culinary world.
Thanks to its simple design, all components
requiring frequent handling for maintenance or
cleaning can be easily assembled or removed.
All users should read this operation manual before
operating the machine.
SWITCHING ON
THE MACHINE

• ADVICE ON ELECTRICAL CONNECTIONS

Before plugging in, check that your power supply
corresponds to that indicated on the machine's
serial number plate.
W A R N I N G
This appliance must be plugged into an
earthed socket (risk of electrocution).
6
Your R 301 / R 301 Ultra is fitted with a single
phase motor. It comes with a power supply cord
which plugs into a standard 120V/60Hz, 15 Amp
grounded power outlet.

• CONTROL PANEL

R 301 / R 301 Ultra
Red knob = Off switch
Green knob = On switch
Black knob = Pulse control
1 speed 1 725 rpm.

• CUTTER BOWL ATTACHMENT

1) With the motor base
facing you, place the
bowl onto the motor
base with the handle
toward the front. Turn
the bowl just off-center
and to the left as you lo-
wer it onto the base.
2) Then, turn it back to
the right to lock it the
base. The handle should
come to a stop at the
front of the motor base.
The bowl, when pro-
perly assembled should
be just off and level with
the top surface of the
motor base.
3) Place the blade onto
the motor shaft. Rotate
the blade until it drops
into place. The bottom
blade should be level
with and just of f the
bottom of the bowl.

ASSEMBLY

The device is now ready for use.

• CITRUS-JUICER ATTACHMENT

1) and 2) Operate the same way as for the bowl
attachment.
3) Place the basket on
the specific bowl delive-
red with the citrus juicer
attachment and rotate
until it clicks. You will
notice that the magnet of
the basket is directly
above the magnetic bar / handle.
4) Place the cone onto the motor shaft and it should
drop into place just off the surface of the basket.
4) Note the plastic tab
on the bowl lid. Place
the lid on the bowl with
the tab turned to the
front and slightly to the
left of the bowl handle;
then, turn the lid back to
the right until it comes to
a stop with the tab over
the bowl handle.