Adjusting The Temperature; Cleaning The Soleplate - TEFAL MINUTE Manual Del Usario

Notice FTB 047257 14/12/05

Adjusting the temperature

• To change the setting from "Min" to "Max", turn the thermostat control
anti-clockwise.
• Set the thermostat control (fig D), according to the table below.
• The thermostat indicator light will come on (fig E). It goes out when the
soleplate has reached the required temperature.
What temperature and steam settings should be used ?
Your iron heats quickly: start
with fabrics that can be ironed
at low temperatures and work
up to finish with those that
require a high temperature.
If you turn down the thermostat
control, wait for the indicator
light to come on before you
start ironing again.
If you are ironing a fabric made
of mixed fibres, set the ironing
temperature for the most deli-
cate fabric.
Care of your iron

Cleaning the soleplate

• While the soleplate is still slightly warm, clean it by wiping over it with a
damp non-metallic cloth.
• The mat can be cleaned by wiping over it with a damp sponge.
• Do not dry clean.
Cleaning the anti-scale valve
• Unplug the iron and empty the tank. To take out the anti-scale valve,
switch to DRY.
• The valve can then be lifted out. Use the grips on the side (fig G) to pull it
out.
• Leave the valve to soak for 4 hours in a glass of white vinegar or natural
lemon juice (fig H) .
• Rinse the valve under the tap. Re-insert the anti-scale valve, using slight
pressure.
15:49 Page 5
F
ABRICS
THERMOSTAT CONTROL
L
IN
C
OTTON
W
OOL
S
ILK
S
YNTHÉTICS
(Polyester, Acetate,
Acrylic, Polyamide)
• Unplug it, put it on the iron stand and wait for the soleplate to cool.
• Empty the tank and set the steam control to DRY. A little water may
remain in the tank.
• Wind the cord around the handle of the iron.
• Fold the mat, place on it the stand with the iron and put them away. It
takes up very little space (fig F) .
(once a month)
POSITION OF THE POSITION OF THE
DRY / STEAM CONTROL
MAX
•••
••
•
•
Storing your iron
Cleaning the ironing mat
Note: the mat cannot be
cleaned in a washing machine.
Machine washing will damage it,
making it unsuitable for ironing.
IMPORTANT! Unplug your iron
and leave it to cool before
cleaning it.
NEVER TOUCH THE TIP OF THE
VALVE.NEVER TOUCH THE TIP OF
THE VALVE.THE IRON WILL NOT
WORK WITHOUT THE ANTI-
SCALE VALVE.
GB
= steam zone
5