Natural Gas Conversion; Lightinginstructions; Control Knob - Ashley Signature P456-776B Guia Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Natural gas conversion must be performed only by your natural gas provider or

service company.

safe and may result in property damage, serious bodily injury or death.

Prior to turning gas on and attempting to light the appliance, make sure the appliance is outside,

in a well ventilated area and free of any debris and is not in contact with or near any people, animals,

materials or structures. Failure to adhere to the above instruction may result in property damage,

serious bodily injury or death.

IMPORTANT, FAILURE TO CAREFULLY READ, UNDERSTAND AND FOLLOW EVERY PART OF THIS

DOCUMENT MAY RESULT IN PROPERTY DAMAGE, SERIOUS BODILY INJURY OR DEATH. DO NOT

ATTEMPT TO LIGHT THE APPLIANCE IF YOU DO NOT UNDERSTAND OR CANNOT FOLLOW ANY PART

OF THIS DOCUMENT. THOROUGHLY INSPECT THE APPLIANCE BEFORE ATTEMPTING TO LIGHT TO

ENSURE PROPER ASSEMBLY AND THAT THE ENTIRE APPLICANCE IS IN GOOD WORKING ORDER

AND IS FREE OF ANY GAS LEAKS. IF YOU NOTE ANY LEAKS, IMPROPER ASSEMBLY OR ANY

DAMAGE TO THE APPLIANCE DO NOT LIGHT THE APPLIANCE AND IMMEDIATELY CONTACT A

QUALIFIED SERVICE TECHNICIAN. FAILURE TO DO SO MAY RESULT IN PROPERTY DAMAGE,

SERIOUS BODILY INJURY OR DEATH"

1. Locate the control and igniter panel. Make sure the control

knob is in the "OFF" position. See Figure 8.Open the tank door

and open the tank valve all the way.

2. Push in the igniter button. You will hear a slight clicking

sound. With the igniter button pushed in, push and turn the

control knob to the "ON" position. The fire should light within

a few seconds. Once the flame is lit, release the igniter button

and continue to hold the control knob in for 10 to 15 seconds.

Release the control knob. The control knob should pop back out

and the fire should remain lit. Note: If the fire does not light, turn

the knob to the "OFF" position and wait five (5) minutes before

trying again.

3. To turn down the flame, push the control knob in slightly and

turn to the Medium (medium flame) or Low (small flame).

4. To shut down the fire pit, turn the control knob to

the "OFF" position and turn off the tank valve

P456-776B/T

DANGER & WARNING