Troubleshooting Guide - Ashley Signature P456-776B Guia Del Usuario

It is recommended that you contact a qualified service technician if you believe the
appliance is not functioning properly.
PROBLEM
Burner won't light
Burner won't stay
lit after lighting
P456-776B/T

TROUBLESHOOTING GUIDE

CAUSE
No Propane Gas at Burner
No Spark at Electrode
Lack of oxygen
Thermocouple not in flame
Thermocouple connection
at the main control valve is
loose
No lava rocks on Burner
REMEDY
Check that gas tank valve is open. Turn
control knob to "ON" and push control knob
in. Make sure tank has propane gas.
Check that AAA battery is installed with
negative (-) end first and has a charge.
Check that the wire is connected to the
ignition module. Check that the electrode
is not cracked or broken.
Remove excess lava rock s or fire ices
from around the ignition well.
Check that the tip of the thermocouple is
even with the top of the ignition well.
Remove any lava rock s from the igntion
well.
Tighten the thermocouple nut at the back
of the valve.
Cover the burner with fire ices per the
instructions.
Page 12 of 12