Emptying The Tub - Tecnoinox FR35G/0 Manual De Instrucciones

Th foods to be fried, as previously mentioned, must
not be too wet. The quantity to be fried must not exceed
2kg. in weight each load. Whilst using the appliance,
To empty the tub use a suitable recipient as regards
capacity and shape and in heat-resistant material.
Cleaning and taking care of the unit
Note: The unit must be cold to clean it.
Remember that a clean unit will work properly and
for a very long time.
The parts that can be removed are to be washed
separately using hot water and detergent. Rinse un-
der running water.
Do not use harsh or abrasive detergents to clean
If there is a malfunction, despite the fact you are
using the unit correctly, the gas supply is correct and
the components are clean and efficient, turn the unit
What to do if the unit is not going to be used for a long time
Clean the unit thoroughly following the instructions
The Manufacturer declines any responsibility for damage caused by improper or incor-
rect installation or maintenance of the appliance, or failure to observe safety regulations!
Frying

Emptying the tub

What to do in case of a fault
GB
6
keep the lid within reach. Replace the frying oil
frequently to avoid the danger of fire.
Connect the tube (A) with a bayonet connection to
the outflow tap (see fig.3) and slowly open the valve.
If the oil or fat is reused, filter it.
the stainless steel parts. Iron cleaning pads should not
be used as they cause the formation of rust. For the
same reason, avoid contact with ferrous materials.
Do not use sand paper or sanded cloth to clean the
unit; in their place, and only under particular circum-
stances, use powdered pumice; in the case of stub-
born dirt a sponge might help (e.g. Scotch) or even
oven and grill spray products that are readily avail-
able on the market. If spray products are used follow
the manufacturer's instructions.
off immediately, stop the gas supply by turning the
upstream cock off, and call the assistance service.
and dry it carefully. Turn off the gas cutoff cock in-
stalled upstream.
IE