Frequently Asked Questions - Faq - Fujitsu LIFEBOOK Bay Projector Manual De Instrucciones

Frequently Asked Questions – FAQ
Frequently Asked Questions – FAQ
This section helps you to resolve problems you may encounter while setting up or using the Bay
Projector.
Some problems may not be directly linked to the Bay Projector. Therefore, also check any other
equipment connected to your notebook.
If you are not able to solve a particular problem, please contact your distributor or Fujitsu Service
Desk.
Problem
The Bay Projector cannot be
switched on.
No picture.
Blue screen
Picture is not sharp
Fujitsu Technology Solutions
Troubleshooting
► Check if the projector is properly installed in the bay,
see chapter "Installing the Bay Projector".
Is the Laser On/Off button blinking?
•
The Laser On/Off button starts blinking orange once
room temperature or Bay Projector temperature are
getting too high.
► Retract the projector part.
► If the problem continues and the button does not stop
blinking, contact your Fujitsu Service Desk.
Are all of control buttons blinking?
•
All of control buttons start blinking when problems
occur.
► Retract the projector part.
► If the problem continues and the buttons do not stop
blinking, contact your Fujitsu Service Desk.
Is the Laser On/Off button solid orange?
After resuming operation from Sleep/Hibernate mode, or
immediately after extracting the Projector Bay, the button
remains orange and there is no picture.
► Press the Laser On/Off button to resume operation
(Laser On/Off button turns green).
Is Disconnect projector selected as display mode?
•
The Bay Projector is switched off.
► Refer to chapter "Switching display modes" to switch
the display mode.
Room temperature is too low.
► Select another location to setup your Bay Projector.
► Adjust image sharpness, see chapter "Using the focus
wheel to adjust image sharpness".
English -
17
17