Heath Zenith 7162 Manual De Instrucciones página 3

W
Wall Mount
Note: Light fixture and sensor should be mounted as shown
above when installed (depending upon type of installation).
INSTALLATION
Setting the Sensor for Wall or Eave Mounting
• For wall mounting, turn the ring around the sensor
clockwise until the "W" and the single indicator is
aligned with the mark on the front of the sensor (see
Figure 1).
• For eave mounting, turn the ring around the sensor
counterclockwise until the "E" and the double indicator
is aligned with the mark on the front of the sensor. (see
Figure 1).
Note: There is a detent at each setting to indicate proper
alignment of the sensor.
Mounting the Solar Light Fixture
Make sure there is enough vertical space above the mount-
ing plate to allow the light fixture to be mounted.
1. Place the mounting plate against the mounting surface
and ensure the mounting plate is level. Mark the hole
locations (see Figure 2).
• If mounting to a wooden surface, drill two 3/32
in. holes into the mounting surface. Install the two
mounting screws through the mounting plate and
into the mounting surface.
• If mounting to wall board or brick, drill two 7/32
in. holes into the mounting surface. Insert the wall
anchors and attach the mounting plate using the
two mounting screws.
2. Install three, 1.5V "C" batteries (not included) into
the battery compartment (see Figure 3). Make sure
the polarity of the batteries is correct.
IMPORTANT: The rechargeable solar battery is pre-
installed in the solar light. The rechargeable battery
is not replaceable.
208824-02
E
Eave Mount
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
W
W
Wall Mount
Figure 1
Figure 2
Figure 3
E
Eave Mount
3