Dyna-Glo DGB730SNB Manual De Instrucciones página 7

ASSEMBLY INSTRUCTIONS
2. Insert 4 screws (A) into holes in bottom shelf (1),
leaving 4-6mm clearance from screw head to bottom
shelf (1). Attached cart left side panel (13) by plac-
ing the panel keyholes over the screw heads (A) on
the left side of bottom shelf (1), slide the cart left side
panel (13) so that the screw head is over the smaller
part of keyhole. Thread the screw (A) down snug but
do not tighten completely at this step. Repeat with
cart right side panel (5).
Hardware Used
A
M6x12Screw
3. Attach cart rear vertical beam (10) to the middle of
thebackinbottomshelf(1)byusingoneM6x12
screw (A). Tighten the screw.
Hardware Used
A M6x12Screw
2
x4
3
x1
A
7
A
13 5
1
5
10
5
13
1
10