Features - RIDGID R82238 Manual Del Operador

SYMBOLS
SERVICE
Servicing requires extreme care and knowledge and should
be performed only by a qualified service technician. For
service we suggest you return the product to your nearest
AUTHORIZED SERVICE CENTER for repair. When servic-
ing, use only identical replacement parts.
WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes, which can result
in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses
with side shields and, when needed, a full face shield. We recommend Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with side shields. Always use eye protection which is marked
to comply with ANSI Z87.1.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.

FEATURES

PRODUCT SPECIFICATIONS
Coupler ...............................................................1/4 in. Hex
Motor .................................................................. 12 Volt DC
Switch .............................. VSR (Variable Speed Reversible)
kNOW YOUR IMPACT DRIVER
See Figure 1, page 11.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
COUPLER
Quickly and easily change bits without the need for tools.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCk)
Your impact driver has a direction of rotation (forward/
reverse/center lock) selector located above the switch trigger
for changing the direction of bit rotation. Setting the direction
SAVE THESE INSTRUCTIONS
6 - English
WARNING:
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator's manual.
If you do not understand the warnings and
instructions in the operator's manual, do not use
this product. Call RIDGID
assistance.
No Load Speed ..................................0-1,800 r/min. (RPM)
Impacts Per Minute ......................................... 0-2,400 IPM
Torque ................................................................ 1,000 in.lb.
of rotation selector in the OFF (center lock) position will lock
the switch trigger to help reduce the possibility of accidental
starting when not in use.
IMPACTS PER MINUTE
This tool features an impact speed of 0-2,400 IPM (the
number of impacts per minute).
LED LIGHT
The LED light, located below the coupler, illuminates when
the switch trigger is depressed. This provides extra light for
increased visibility.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
customer service for
®