EMKO ESM-4435 Manual De Instrucciones página 14

Aln2 ConF: Alarm-2 Output Configuration Parameters
i
"Aln2 Conf" Menu is accessible if
ConF" is
Determines logic output function for Alarm-2 Output.
Alarm output
Manual /Automatic selection output
Sensor break alarm output
Output is active when the process value is out of the band which
is defined with minimum value of operating scale
maximum value of operating scale
Determines Alarm type for Alarm-2 Output.
It is active if logic output function of Alarm Output-2 is alarm output.
Process high alarm.
Process low alarm.
Deviation high alarm.
Deviation low alarm.
Deviation band alarm.
Deviation range alarm.
Alarm- 2 hysteresis value.
Active if logic output function of Alarm-2 Output is alarm output.
Alarm on delay time for Alarm Output-2.
It can be adjusted from 0 to 9999 seconds. It is active if logic output
function of Alarm Output-2 is alarm output.
Alarm off delay time for Alarm Output-2.
It can be adjusted from 0 to 9998 seconds. When the value is bigger
than 9998,
is selected. It is active if logic output function of Alarm Output-2 is
alarm output.
Alarm stabilisation time for Alarm Output-2.
It can be adjusted from 0 to 99 second. Logic output function of
Output2 if is selected as Alarm ,ALS2 parameter will be activated.
After the unit is power-on and Alarm Stabilisation Time is expired,
Alarm Output-2 becomes active when the alarm conditions realised in
Alt2 parameter.
is seen on the screen. It means alarm latching output
parameter in "PCnF
and
14