Panel Mounting - EMKO ESM-4435 Manual De Instrucciones

DIMENSIONS
ESM-4435
°C
°F
V
PO M A
AO1
AO2
AT PSET ASET1 ASET2
AT A/M
P
Process Controller
48mm/ 1.89 inch

PANEL MOUNTING

5
4
SET
11.5 ± 1 mm /0.45 inch
1
3
2
Maximum 5mm / 0.2 inch
1- Before mounting the device in your panel,
make sure that the panel cut-out is suitable.
2- Check front panel gasket position
3- Insert the device through the cut-out. If the
mounting clamp are on the unit, put out them
before inserting the unit to the panel.
4- Insert the unit in the panel cut-out from the
front side.
5- Insert the mounting clamps to the holes
that located top and bottom sides of device
and screw up the fixing screws until the unit
completely immobile within the panel.
76mm / 2.99 inch
4