EMKO ESM-4435 Manual De Instrucciones página 6

Run LıSt: Selection of PID Tune and Operation Form
TUNE SELECTION:
By selecting one of the methods below, device can determine the PID
parameters.
Device operates according to the defined PID.
Auto tune (Limit Cycle Tuning) operation.
Self tune (Step Response Tuning) operation.
Auto-Self Tune Self Tune operation is performed, if the conditions are
realized when power on firstly.
AUTOMATIC TUNE SELECTION
Device does not perform tunning.
Device does perform tunning.
BUMPLESS TRANSFER
Process output value in manual control is not taken into
consideration while passing from manual control to
automatic control. New control output that is measured in
automatic control is applied to process output.
Last % process output value in automatic control is accepted as
process output value of manual control and manual control
continues to run.
ALARM LATCH CANCELING
Alarm latch canceling is not performed.
If there is an alarm output with latching and there is no alarm
status, latching operation will be finished by the device.
When it is finished, this parameter becomes
Automatically.
dıSP LıSt: Function Selection for Top and Bottom Display
It defines the function of the top display. This parameter determines
which value is shown in top display.
Process value (PV) is shown in top display.
Difference between process set value and process value(SV-
PV) is shown in top display.
It defines the function of the bottom display. This parameter
determines which value is shown in bottom
Process set value (SV) is shown in bottom display.
6