Replacement Parts - Sunex Tools 8013A Instrucciones De Operación

PARTS BREAKDOWN
Step 8: Inserting locking drawer assembly
into the cart.
Before inserting the drawer into the service cart,
make sure the roller bearing case is extended all
the way out to the black plastic end stop. This will
ensure proper alignment during insertion. Hold the
roller bearing case in place while inserting the drawer.
If necessary, adjust the drawer rails to allow the drawer
to slide on smoothly. DO NOT FORCE THE DRAWER
ONTO THE SLIDE RAILS.
Step 9: Attaching casters.
With the keys provided, lock both the locking top
assembly and the locking drawer assembly. This will
prevent the drawer and top from opening when you
turn the cart upside down to attach the casters. Once
the top and drawers are locked, turn the cart upside
down so the legs are facing up and you can see the
plastic inserts where the casters will be inserted. Insert
the stem of the caster into the hole in the plastic insert.
Using the rubber mallet, hammer the casters in place
until the stem is no longer visible. Repeat with the other
three casters. NOTE: Make sure both locking casters
are either on the right hand side or left hand side of
the cart. Once all casters are installed, stand the cart
upright. Assembly is complete.
2
4
6
8013A/8013ABK/8013ABL: Parts Breakdown & Operating Manual
SERVICE CART WITH LOCKING TOP & DRAWER
2
5
3
MODEL 8013A / 8013ABK / 8013ABL
8.
9.

REPLACEMENT PARTS

Item Part # # Req'd
2 RSSC7 2
3 RSSCPLW 2
4 RSSCPW 2
5 RSSCPP1 1
6 RSSCPHK 1
Also Available
RS8006HDL
RS8006HDLB
RS8006LK
RS8006LK2
RSRBSLIDEC2
RSDET8PK
4
Description
Chrome Leg/ea.
Locking Caster/ea.
Non-Locking Caster/ea.
Set of 4 Plastic Inserts
Bolt Kit (Incl. 8 ea. of 10mm
and 14mm bolts, washers, lock
washers, nuts and 4 screws)
Chrome Drawer Handle
Black Drawer Handle
Drawer Lock with Keys
Matching Locks with Keys
for Drawer and Top/pr.
Clip-On Roller Bearing Slides/pr.
Detents for Slide/8pk.
rev. 06/11/18