Chaparral Monterey Instrucciones De Montaje página 10

Y
x 4
x2 drawers
Z
x 4
V
x 4
READ CAM-LOCK INSTRUCTIONS
12. Insert four Cam Connectors (Y) in the Drawer Front (L). Attach Left Drawer Side (M) and
Right Drawer Side (N) to Drawer Front (L) with four Cam Housings (Z). Make sure that the
Cam Housings are facing out from the drawer and the grooves for the drawer bottom match.
Tighten cam housings. Slide the Drawer Bottom (O) into the grooves. Attach the Drawer
End (P) to the drawer sides using Screw (V) as shown in Figure 12A.
Square the drawer by measuring from left front to right rear and from right front to left rear.
The measurements should be equal. If one is longer, hold the drawer by the corners on the
longest line and squeeze them together until square. See Figure 12B.
x2 drawers
BZ
x 4
AZ4
FIG. 13
13. Attach Drawer Slides (Drawer Side Left) (AZ4) and (Drawer Side Right) (AZ3) to the drawer.
The wheels should be to the rear and the front edge should be flush against the back of the
Drawer Front. Attach each slide with two Screws (BZ). See Figure 13.
Repeat Steps 12 & 13 for the other drawer.
Page 10 – 549W
x2 drawers
Y
Z
x2 drawers
FIG. 12A
BZ
BZ
Y
V
V
FIG. 12B
AZ3
BZ
Z
V
V
The drawer slide will be stamped with an
"L" for left or an "R" for right in the center of
the wheels. Or they will be stamped on the
body of the slide: "DL" for drawer left; "DR"
for drawer right.
BZ