Operating Instructions - RIDGID POWER SPIN+ Manual Del Operario

POWER SPIN+ ™ Drain Cleaner
er distance from the drain access
creases the risk of the cable twisting or
kinking. If not, the drain opening will
need to be extended using similar size
pipe and fittings so that the drain cleaner
can be placed within 4" of the drain
opening (see Figure 7). Improper cable
support can allow the cable to kink and
twist and damage the cable/fixture or
injure the operator.
Figure 7 – Example of Extending Drain to Within
4" (100 mm) of Drain Opening
Operating Instructions
WARNING
Always use safety
work gloves in good condition while hanw
dling or using. Use latex or rubber gloves,
face shields, protective
tors or other appropriate
quip ment when chemicals,
other toxic or infectious
suspected to be present
risk of infections,
personal injury. Wear latex gloves
ber gloves under leather gloves.
Follow operating
the risk of injury from twisted
ken cables, cable ends whipping
machine tipping, chemical
tions and other causes.
1. Make sure that machine and work area is
properly set-up and that the work area is
free of bystanders and other distractions.
2. Assume a proper operating position that
will allow
• Good balance and not require any over -
reaching.
4
glasses and leather
clothing, respiraf
protective
bacteria
substances
to reduce
burns or other serious
or rubp
instructions to reduce
or brot
around,
burns, infecm
• Control of the drain cleaner (and bat•
ine
tery powered drill if used).
• Ability to maintain the unit 4" (100 mm)
or less from the drain opening.
This will help maintain control of the cable
and machine.
3. Pull cable out of the drum and push into
drain as far as it will go. At least one foot
of cable must be in the drain so that the
cable will not come out and whip around
when the cable starts turning.
4. If using a battery powered drill, confirm
set to low speed (less than 500 rpm) and
with dry hands insert the battery, but do
not place you finger on the drill switch yet.
5. Make sure that the drain cleaner is within
4" (100 mm) of the drain opening, and
maintain that distance throughout the
cleaning process. This helps to prevent
twisting and kinking of the cable.
6. Place one hand on the drain cleaner han6
dle/trigger and other hand on the drill
grip or the crank handle.
7. Turn the drum clockwise (as marked with
an arrow on the back of the drum, see
Figure 2) and squeeze the drain cleaner
trigger. Squeezing the trigger advances
the cable into the drain.
Cable can also be rapidly advanced/reC
tracted by feeding in and out of the drum
by hand.
e -
or
are
the
Figure 8 – In Operating Position
8. Continue to advance the cable until the
re8 sistance is encountered. Carefully
work the cable through the blockage.
Do not force the cable – if the cable stops
turning, it is not cleaning the drain. It
may be neci essary to spin the cable
without advancing it, or advancing the
cable very slowly. This will help to break
up the blockage.
9. If the cable becomes stuck in the
block9 age, do not continue turning
the drum.