For Energy Conservation; Reinstallation Of Shipping Materials - Alliance Laundry Systems SWD439C Guía De Uso Y Cuidado

Maintenance

For Energy Conservation

Make sure the lint filter is always clean.
G
Do not overload dryer.
G
Do not overdry clothes.
G
Remove items to be ironed while still damp.
G
Large loads of similar fabrics dry the most
G
efficiently. However, dry permanent press in
smaller loads to prevent wrinkling.
Use the correct temperature FABRIC
G
SELECTOR setting for the type of fabric being
dried.
Locate your dryer so the exhaust duct is as short
G
and straight as possible.
Do not open the door during the drying cycle.
G
Plan to do your laundry on low humidity days;
G
your clothes will dry faster.
Should you plan to dry several loads, do them
G
one after another, then you do not have to reheat
the dryer's interior parts each time.
24 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Reinstallation of Shipping Materials

Remove front access panel by removing two screws.
Place the shock sleeves on all four shock absorbers.
Refer to Figure 8.
Insert hooked end of shipping brace into the open slot
of the motor mount. Attach with bolts and washers.
Refer to Figure 8.
Reinstall front access panel.
4
3
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
Figure 8
Refer to the INSTALLATION INSTRUCTIONS for
proper procedures whenever the washer is moved.
1
2
H336I
800938