xtpower MP-24000 Manual Del Usuario página 4

Disposal
- Batteries and Power Banks should not be disposed of with
household waste.
- Recycling and disposal of waste batteries and Power Banks
make an important contribution to protect our environment.
- Batteries Directive: 2006/66/EC
CE Declaration of Conformity:
- This product bears the required CE marking according to
Directive 2004/108/EC. The product meets the essential
requirements of the European directives and regulations.
Charging the Powerbank:
- Your powerbank will be shipped partly charged. Please
charge it full before first time using.
- You will recognize the charge status after first time switch
on (on/off).
- Please connect the powerbank with the power adapter
(Input) and connect the power adapter 100-240V 50/60Hz.
- The active function is indicated by the flashing of an LCD
and the battery symbol. The number of switched on LCD´s
shows the current state of the powerbank during charging.
In addition, a digital display is shown.
- After full charging process l all 5 LEDs are switched on, you
can then pull off the power.
- Please store the powerbank never extended time in a
discharged state, but charge them again when getting
discharged.
- The charging indicator is carried out by the internal battery
voltage measurement. Therefore it may occur at the
beginning of the load a surge of displayed capacity.
Load your mobile device via the USB port
- Please locate the appropriate connector for your device,
connect it to the USB cable, and then plug that into your
device.
- you can also use the original USB cable of your device.
- plug the USB cable into the USB socket
- when the device is not automatically been charged, then
briefly press the switch button (on / off). Your device is
now charged. The ppwerbank LED's indicate the current
charge status of the powerbank. A USB icon indicates that
the USB connector is plugged into either socket.
- once your device is fully charged or the capacity of the
powerbank is depleted, the powerbank automatically turns
off.
www.xtpower.de
Load your mobile device via the DC jack ( Output)
- choose the correct output voltage with the switch on the
side of the powerbank (12V/16V / 19V).Important: Make
sure before connecting the device to use the correct
voltage , otherwise your device may be damaged.
- connect the pin plug adapter cable with power bank
(output) .
- locate the appropriate connector for your device and
connect it to the cable.
- turn on the power bank as described above
- your device is now being charged. The LED 's indicate the
current charge status of the powerbank .
- when your device is fully charged or the capacity of the
powerbank is depleted , the power bank will turn off
automatically .
- please note that if your device is in operation and the
battery of your device is not fully charged, then the
powerbank supports your device and in parallel is charging
the device battery . If the sum of the currents then will be
too high, the power bank will turn off automatically , or the
operating time of the powerbank is reduced
disproportionately by the high discharge current.
- we recommend the powerbank to be used with devices
whose battery is fully charged or where the device battery
is charged when the unit is not in operation.
- if consumers are connected which only need a small
current which is below the end of charge current then the
current will also turn off after a short time and the device
unfortunately cannot be charged or operated.
140202
MP-24000