Waterpik WP-860 Manual De Instrucciones página 17

32
GETTING STARTED WITH YOUR TRIPLE SONIC TOOTHBRUSH /
CARE OF YOUR TRIPLE SONIC TOOTHBRUSH
Charging the Triple Sonic
Toothbrush
Charge for 24 hours before first use. All 3
charge indicator lights will stay on continuously
when the unit is fully charged. A full charge will
last for approximately 20 pretimed brush cycles, or
approximately 10 days, if brushing twice daily.
If the toothbrush is to be stored for an extended
period of time (three months or more), be sure to
fully charge it prior to storage.
Modes
Clean: Standard mode for superior teeth cleaning.
Whiten: Teeth cleaning with polishing and
whitening.
Massage: Pulsates for gentle gum stimulation.
Recharge Indicator Lights
Fully charged
CHARGE
/
2 charged
3
CHARGE
/ charge life
1
3
(recommend
CHARGE
recharge)
Unit will not operate if the
bottom LED begins to blink
rapidly.
In order for the toothbrush to
CHARGE
begin to work again, it must
be placed on the charger for
approximately 1 hour.
20021731-FAB_861B_IM_R3.indd 32-33
Sonic brushing
• Slide the brush head onto handle and
push it down firmly.
• Select mode by pressing mode button
until light is by desired mode then
press On/Off button.
• Place the brush head into your mouth
before turning the unit on.
• For best results, position brush along
gumline at a 45-degree angle.
• Use light pressure with a small, slow back
and forth motion covering one or two teeth at a
time.
• Quad Timer: Your Triple
Sonic Toothbrush will
create a short pause every
30 seconds, to remind
you to move to the
next quadrant of
your mouth.
• 2-Minute Timer:
The brush will
automatically shut off after 2 minutes of run time.
Cleaning
1. After each use,
turn off unit, remove
the brush head from
the handle and rinse
brush head under
running water.
2. Wipe the handle dry
after each use.
Service
Waterpik ® toothbrushes have no consumer
serviceable or replaceable electrical items and
do not require routine service maintenance. For
all your warranty and accessory needs, please
visit www.waterpik.com/intl to find your local
distributor. Please do not ship product to Waterpik
International, Inc. offices, this will delay service.
Refer to the serial and model numbers in all
correspondence. These numbers are located on
the bottom of your unit.
Disposal
This product contains rechargeable Nickle Metal
Hydride batteries. The batteries are not replaceable.
Please do not dispose of the unit in the household
waste. Remove the batteries per the instructions
below and recycle at your local recycling center.
Battery Removal
Note: This process is not reversible
Remove the battery only at the end of the product's
life for recycling. Doing so earlier will destroy the
product. Deplete the battery charge until the brush no
longer operates. Observe basic safety precautions.
Remove the batteries as shown and recycle them and
the rest of the product according to local regulations.
1. Use a screwdriver to remove the screw and
battery door.
1
2. Hold the handle upside down, press the
toothbrush shaft, and release the two tabs
inside the handle using a flathead screwdriver
to release the internal components of the
handle.
2
3. Insert the screwdriver next to the battery
connections, and twist to break the
connections. Remove the circuit board and pry
the battery from the circuit carrier.
3
Batteries
4. Recycle or dispose of the battery properly.
9/8/16 4:13 PM
33