Seko TEKNAEVO TPG Manual De Instalación página 11

Paragraph 13 – Password
Programming
PROG
-
-
Password
****
Password
0000
-
Paragraph 14 – Flow Alarm
Programming
PROG
-
-
Alarms Alarm Flow
Flow Off Off
Alarm Flow
On
-
Alarm Flow - On
Signals
Alarms
Flow
Paragraph 15 – Level Alarm
Programming
PROG
-
-
Alarms
Level Stop
-
Paragraph 16 – Flow Display Unit
Programming
EM00136061
-
+
-
+
-
-
+
6
ESC
Off
-
Alarm Level
Stop
-
Alarm Flow
Alarm
ESC
Alarms
Level Alarm
-
By entering the password, you can enter the programming
menu and see all the set values. The password will be
requested whenever you seek to modify them.
The flashing line indicates the number than can be modified.
Use the key to select the number (from 1 to 9), and the
key to select the number to be modified. Confirm by
pressing the
password is eliminated.
This makes it possible to activate (deactivate) the flow
sensor.
When activated (On), press the
request for the number of signals that the pump waits for
before an alarm is triggered. The number flashes when you
press the key, and you can then use the
to set the value. Confirm by pressing the
to return to the main menu
This makes it possible to set the pump when the level
sensor alarm is activated. In other words you can decide
whether to stop dosage (Stop) or simply activate the alarm
signal without stopping dosage.
Changes can be made by pressing the
the keys to set the alarm type. Confirm by pressing
the key. Press
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the
the keys to set the unit of measurement, choosing
between L/h (liters/hour),
(milliliters/minute) or standard (% or frequency, depending
on settings). Press
menu
rev. 2.1
Operation
key. By setting "0000" (default), the
Operation
key to access the
Operation
to return to the main menu
Operation
Gph (Gallons/hour),
to confirm and return to the main
keys
key. Press
key, then using
key, then using
ml/m
10