Seko TEKNAEVO TPG Manual De Instalación página 12

Paragraph 17 - Setting the Pause
Programming
PROG
Configuration
+
Paus
N.Open
-
Display contrast adjustment.
For adjusting the display contrast keep the key
increase or decrease the contrast.
Alarms
Display
Fixed alarm LED
Flashing word "Lev"
I.e.
Man
Lev
Fixed alarm LED
Flashing words "Lev" and "stop"
I.e. Man
Lev Stop
Flashing word "Mem"
I.e.
1:n
Mem
Flashing word "Mem"
1:n M
I.e.
Mem
Fixed alarm LED
Flashing word "Flw"
I.e. Man F
Flw
I.e. Parameter Error
PROG to default
EM00136061
-
+
-
End of
interrupting pump operation
P100%
End of level alarm, with interruption
to pump operation
P100%
The pump receives one or more
pulses during dosage with memory
6
function on Off
The pump receives one or more
6 pulses during dosage with memory
function on On
Active flow alarm. The pump has
not received
number of signals from the flow
sensor.
P100%
Internal CPU communication error.
The pump can be paused by remote input.
The factory setting is Normally Open.
Changes can be made by pressing the
using the
N. CLOSED).
Press to confirm and return to the main menu.
pressed and within 5 seconds press the keys
Cause
level alarm, without
the programmed
rev. 2.1
Operation
keys to set the new value ( N. OPEN or
Interruption
Restore the liquid level.
Restore the liquid level.
Press the key
When the pump finishes receiving
external impulses, it returns the
memorized strokes
Press the key
Press the key to restore the
default parameters.
key, then
or to
11