Installation; Getting Started - Klarstein 10028130 Manual Del Usuario

• Take out all the packing. If there is a safe film over the oven, tear it off before Use. Check carefully
for damage. If any, immediately notify dealer or send to the manufacturer's service center.
• Microwave ovens must be placed under dry and non corrosiveness environments, kept away from
heat and humidity, such as gas burner or water tank.
• To ensure sufficient ventilation, the distance of the back of microwave to the wall should be at least
10 cm, the side to the wall should be at least 5 cm, the free distance above the top surface at least
20 cm. the distance of the microwave to the ground should be at least 85 cm.
• The position of the oven shall be such that it is far from the TV, Radio or antenna as picture distur-
bance .The distance should be more than 5m.
• The appliance must be positioned so that the plug is accessible.
• The microwave oven must be operated with the door closed.
• The microwave must not be placed in a cabinet. The microwave oven is intended to be used freestanding.
• The back of the oven must be placed against a wall
• As there is manufacturing residue or oil remained on the oven cavity or heat element, it usually
would smell the odor, even a slight smoke, It is normal case and would not occur after several
times use, keep the door or window open to ensure good ventilation. So it is strongly recommen-
ded to set the oven to grill mode and operate dry several times.
The LED flashes 3 times when plugged in power supply. Then it flashes ":", prompting you
to input the cooking menu and time.
Auto reminder
When your preset cooking procedure has finished, the LED Display will show End and
three beeps sound will be heard to prompt you to take out food. If you do not press
Pause/Cancel button once or open the door, the beep will sound at an interval of 3
minutes.
Clock setting
Clock button make it available for you to input current or preset time when ":" flashes
onto LED display after plugged in, or try to skip it over to continue if unnecessary.
Example: How to set 12:30
Steps
1
After power-up, the colon flashes .
2
Press Clock button once.
3
Turn Time/Weight knob to set exact hours.
4
Press Clock button once again.
5
Turn Time/Weight knob to set exact minutes.
6
Press Clock button once again or wait for 5 seconds, and the numbers
will go steadily.

Installation

Getting Started

Display
:
00:00
12:00
12:00
12:30
16