Tools And Materials; Before You Begin - Kohler K-T73087-4 Guía De Instalación Y Cuidado

Tools and Materials

Sealant Tape

Before You Begin

CAUTION: Risk of personal injury. Do not use the bath
filler as a grab bar or support bar when entering or exiting
the bath. The bath filler is not designed to support weight.
NOTICE: To avoid damage to the O-rings on the bottom of the
faucet, keep the faucet vertical and use care when installing the
faucet.
NOTE: A minimum operating pressure of 45 psi (310 kPa) is
required for proper operation. If a pressure of less than 45 psi (310
kPa) is present, contact a plumber or choose another faucet.
For use with automatic compensating valves rated at 1.6 gal/min
(6.1 l/min) or less.
Observe all local plumbing and building codes.
Shut off the water supply.
A drill bit is provided for installation to wood support. Use an
appropriate drill bit for other materials.
The dimensions given assume the spout and bath are mounted on
the same surface. Adjust the dimensions accordingly if the spout
and bath are mounted on different surfaces.
If this product is installed with an overflowing bath, the outer rim
of the bath should slightly overlap the 2x4 framing.
Installer supplied copper tubing must be 5/8" OD (1/2"
Nominal).
Carefully review this document and all appropriate roughing-in
information. Design the bath enclosure accordingly.
1246878-2-A
Plus:
• 3/16" Masonry Bit (for concrete installation)
• Conventional Woodworking Tools and Materials
• Plumbing Tools and Materials
2 Kohler Co.