Chinstrap With Micro-Lock Ratchet Fastener - SCHUBERTH C3 PRO Manual Del Propietário

D. THE HELMET

10. CHINSTRAP WITH MICRO-LOCk RATCHET FASTENER

The C3 Pro comes with a ratchet fastener. This
locking system is easy to use and
enables you to adjust the chinstrap
perfectly to your head every
time you put the helmet on.
Adjusting the chinstrap
The length of the chinstrap is adjusted by increasing or reducing
the length of strap pulled through the metal buckles. Adjust
the length of the chinstrap so that it fits firmly but comfortably
under your chin and fix the end of the strap using the retaining
loop with comfort pad.
Caution:
When adjusting the strap, make sure that the helmet cannot
be pulled off in a forward direction with the chinstrap closed
Caution:
Check the adjustment of the chinstrap length at regular
intervals (see section F.2.).
18
Opening and closing
To close the chinstrap fastener, slide the ratchet tongue step by
step into the locking buckle. If you find that the chinstrap fits
too loosely around your chin, slide the ratchet tongue one step
further into the locking buckle.
When adjusting the chinstrap, make sure that it rests firmly but
not uncomfortably around your chin. To open the chinstrap, pull
the red ribbon on the ratchet fastener upwards to release the
locking buckle. Then pull the ratchet tongue out of the locking
buckle.
Caution :
Never ride without making sure that the chinstrap is correctly
fastened and adjusted and properly positioned. If the
chinstrap is not correctly adjusted or fastened, the helmet
could be displaced in the event of an accident.
Caution :
Closing the comfort pad of the chinstrap alone will not
provide adequate protection. The chinstrap must always be
fully fastened.
Caution :
Never open the chinstrap while riding.
19