Using The Hair Clipper; Blade Maintenance - Panasonic ER1611 Instrucciones De Uso

AC operation

If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it even if the battery
capacity is low.
•
If the clipper does not operate, charge the clipper for
approximately 1 minute.
•
Be careful not to discharge the battery completely with the power
left turned on. It results in shortening the battery life.
Cut
Using the hair clipper
Turn the dial clockwise or counterclockwise to
adjust the moving blade back and forth to get the
desired height. Adjustable in 5 stages from 0.8 mm
to .0 mm in 0.3 mm steps without attachments.
Using the comb attachments

1
1
Select the trimming heights
indicated on the insides and
sides of the attachments.
2
2
Set the dial to "0.8" and then
mount the attachment to the
clipper as illustrated.
Removing the attachment from the clipper
Slide one side of the attachment off the
mounting in direction indicated with the arrow.
4
Care
Blade maintenance
Removing and mounting the blade
Removing the blade

1. Hold the clipper with the switch
facing upward and push the
blade with your thumb while
catching the blade in your other
hand.
•
Be sure to turn off the power
before you remove the blade.
0.8
Mounting the blade

1. Set the dial to "2.0".
0.8
2. Fit the mounting hook into the
blade mounting on the clipper
and push in until it clicks.
2.0
2.0