Installation Instructions - Frigidaire CFRE4120SW Manual De Uso

Electrical connection (non-Canada) - 3 wire cord
3-wire receptacle
(NEMA type 10-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could
result in personal injury or even death.
1 Turn off power supply to outlet.
2 Remove the screw securing the terminal block access
cover in the upper corner on the back of the dryer.
3 Install a UL-approved strain relief according to the
power cord/strain relief manufacturer's instructions in
the power cord entry hole below the access panel. At
this time, the strain relief should be loosely in place.
4 Thread an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 10-30 type SRDT, through the strain relief
opening.
5 Attach the power cord neutral (center wire) conductor
to the SILVER colored center terminal on the terminal
block. Tighten the screw securely.
6 Attach the remaining two power cord outer conductors
to the outer, BRASS colored terminals on the terminal
block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/conductor at
connections.
7 Follow manufacturer's guidelines for fi rmly securing the
strain relief and power cord.
8 Reinstall the terminal block cover.
IMPORTANT
If moving dryer from a 4-wire system and installing it in a
3-wire system, move the internal ground from the center
terminal back to the GREEN screw next to the terminal
block.

INSTALLATION INSTRUCTIONS

NEMA 10-30 NEMA 10-30
DO NOT remove internal
ground in a 3-wire system!!
30 AMP 30 AMP
Terminal
cover
Neutral
terminal
Neutral Neutral
(center wire) (center wire)
11